Introducing our next-level Windshield Crack Repair Kit. This tool keeps your windshield intact, stops chip spread, and greatly reduces visibility of cracks. It's a must-have for every motorist.
Damage left unattended tends to spread; prevent this by tackling the repair soon after it occurs. Also, remember to protect the affected area with scotch tape immediately after damage.
Our repair kit works best on rounded damage, preferably within one inch in diameter and cracks not exceeding 12 inches. Please be informed, multi-layered glass damage cannot be handled with this kit.
If you're seeking prevention against minor windshield damage and spread, then this Windshield Crack Repair Kit is your perfect companion. Simple to use and highly efficient, it's the true hero of windshield upkeep.
Clean the area around the chip or crack thoroughly with a dry towel. Make sure there are no loose glass fragments.
Position the repair device over the chip, ensuring the center ring is directly aligned with the impact point.
Screw the resin chamber into the center ring until it touches the chip. Make sure the chamber is tightly secured to create an airtight seal.
Insert resin into the chamber by adding 3-6 drops, depending on the size of the chip.
Ensure the resin is fully inside the chamber, ready to be pressed into the crack.
Tighten the pressure driver on top of the resin chamber until it begins pressing the resin into the chip. This step helps fill the chip completely with the resin.
Loosen the pressure driver slightly to release any trapped air, then re-tighten to press more resin into the chip. Repeat as needed until the chip is filled.
Remove the repair device carefully from the windscreen.
Apply curing strips over the repaired area to protect the resin while it cures.
Move the vehicle into direct sunlight and allow the resin to cure.
After the resin is fully cured, scrape off any excess with the provided razor blade, leaving a smooth surface.
$69.99